How to clean geothermal filter
The floor heating filter is an indispensable part of the floor heating system. Its function is to filter impurities in the water and ensure the normal operation of the floor heating system. However, after long-term use, the filter will accumulate a large amount of dirt, affecting the efficiency of the system. This article will introduce in detail the cleaning method of the floor heating filter, and attach relevant data to help you better maintain the floor heating system.
1. The necessity of cleaning the geothermal filter
The main function of the geothermal filter is to intercept impurities such as sediment and rust in the water and prevent them from entering the floor heating pipes. If the filter is not cleaned for a long time, it will cause the following problems:
| question | influence |
|---|---|
| Poor water flow | Decreased heating efficiency of floor heating system |
| Impurity accumulation | Increased risk of pipe blockage |
| Increased energy consumption | The system requires more energy to maintain temperature |
2. Steps to clean geothermal filter
Cleaning a geothermal filter is not complicated, but you need to follow the correct steps:
| steps | Operating Instructions |
|---|---|
| 1. Shut down the system | Make sure the underfloor heating system is completely out of service |
| 2. Bleed the water pressure | Open the drain valve to release the water pressure in the pipe |
| 3. Remove the filter | Use the tool to unscrew the filter housing |
| 4. Clean the filter | Rinse the filter with clean water to remove impurities |
| 5. Check the sealing ring | Make sure the sealing ring is not damaged and replace if necessary |
| 6. Reinstall | Put the filter and housing back into place |
| 7. Restore the system | Open the water inlet valve and check for leaks |
3. Cleaning frequency recommendations
The frequency of cleaning the geothermal filter depends on the water quality and usage environment. The following are common cleaning cycle recommendations:
| water quality | Recommended cleaning cycle |
|---|---|
| Better water quality | Clean once a year |
| Water quality is average | Clean once every six months |
| poor water quality | Clean every 3 months |
4. Cleaning precautions
When cleaning geothermal filters, you need to pay attention to the following points:
1.Safety first: Make sure the system is completely shut down and drained of water pressure to avoid burns or water pressure shock.
2.Gentle operation: The filter is relatively fragile, so avoid using too much force to cause deformation when cleaning.
3.Check accessories: After cleaning, check whether the sealing ring and shell are intact to prevent water leakage.
4.Professional help: If you are not familiar with the operation, it is recommended to contact a professional for cleaning.
5. Frequently Asked Questions
Q1: What should I do if the floor is still not hot after cleaning?
A1: There may be air or other blockage problems in the pipeline. It is recommended to exhaust or contact a professional for inspection.
Q2: Can chemical cleaning agents be used?
A2: It is not recommended to use strong acid and alkali cleaning agents to avoid corrosion of the filter screen or pipes.
Q3: What should I do if the filter is damaged?
A3: The filter needs to be replaced immediately to prevent impurities from entering the pipeline.
Summary
Regular cleaning of the floor heating filter is an important part of maintaining the floor heating system, which can effectively improve the heating efficiency and extend the life of the system. By following the steps and precautions provided in this article, you can easily complete the cleaning job. If you encounter complex problems, it is recommended to seek professional help in time.
check the details
check the details
en
